Protocolが成功すると良いなあまり期待はしていないがｗ https://stap-hope-page.com/
https://web.archive.org/web/20160331060038/https://stap-hope-page.com/
https://stap-hope-page.com/protocol-for-stap-cells
Preparation of Reagents ATP solution Adenosin5’-triphosphate disodium salt hydrate (Sigma, A3377) Water (Sigma, w3500, RNBC5693) Dilute 110.57mg of ATP into 1ml of H2O（200mM in H2O）
Sterilize the ATP solution through a sterilizing filter
Aliquot in 30μl increments
Store at -20℃
*It was confirmed that ATP (Adenosin5’-triphosphate disodium salt hydrate) is soluble in water at this concentration. **ATP weight is shown not a theoretical value but a measured value which produced the best results. ATP weight was determined based on a change of the pH value. bFGF solution bFGF (WAKO, 060-04543, 100μg) PBS (Gibco, 14170) Dilute 100μg of bFGF into 100μl of PBS
Aliquot in 10μl increments
Store at -20℃
B27 medium F12/DMEM 1:1 (Gibco, 11330) B27 (Gibco, 17504) LIF (Millipore, ESGRO, mLIF, ESG1107) Add 10ml of B27 and 50μl of LIF into 500ml of F12/DMEM medium
Sterilize the mixture through a sterilizing filter
Store at 4℃
Materials and Equipment 1 week-old mice (2 to 3 of spleens, or other tissues*) HBSS (GIBCO, 14170) Lympholyte-M (CEDARLANE, CL5031) ATP solution B27 medium 15ml conical tube Filter mesh (pore diameter:40μm) Pasteur pipette Micro pipettes and their tips Pipette aid and their tips 24 well culture dish Swing rotor centrifuge 5% CO2 incubator Sterilized small scissors Methods Harvest spleens from 1 week-old mice
Put spleens into a 15 ml tube and mince them well to a paste with sterilized small scissors
Add 5.5ml of HBSS
Suspend the spleen paste in HBSS through a Pasteur pipette
Strain the solution through a filter mesh (pore diameter:40μm) and collect the strained solution into a new 15ml conical tube
Add 5ml of Lympholyte-M slowly into the bottom of the conical tube
Centrifuge the conical tube at 1500g, 20 min, RT in a swinging bucket rotor
Carefully collect a layer of lymphocytes as per standard procedure and put cells into a new15 ml conical tube**
Centrifuge the conical tube at 800g, 10 min, RT
Carefully the discard the supernatant
Add 500μl of HBSS and suspend a cell pellet using a 1000μl-pipette***
Take out 6μl of the cell suspension for cell counting
Add 6μl of ATP solution (At this moment, the color of HBSS changes from red to yellow)
Incubate the cells horizontally at 37℃ (in the 5% CO2 incubator) for 15 min**** (During this time, count the number of cells)
Centrifuge the incubated cells at 1500rpm, 5min, RT
Carefully the discard supernatant*****
Add B27 medium at 1×106 cells per ml
Add 1μl of bFGF solution per 1ml to the cell suspension
Plate the cell suspension, 1ml per well in a 24-well culture dish
Place the culture dish into the 5% CO2 incubator and culture until cells form cell clusters (approximately for a week)
Recipes *Liver would be easier than other tissues. At the verification experiment of STAP, Dr. Niwa’s group independently succeeded the recreation of cell clusters which expressed pluripotent stem cell markers such as Oct4 and Nanog from liver cells (see http://biorxiv.org/content/biorxiv/early/2015/09/28/027730.full.pdf). *Sub-cultured cells or previously frozen stocked cells tend to not form cell clusters. I highly recommend the primary culture **Contamination of red blood cells prevents cells from forming cell clusters. ***At this point, Dr. Vacanti and Dr. Kojima highly recommend to trituration of the cells with a thin-glass pipet (A). Also, I recommend using SLO (Streptolysin O) treatment if the cells don’t form clusters well (B). (A) Trituration Burn a Pasteur pipette and stretch it out to make a thin-glass pipette.
Pass the cell suspension through the thin-glass pipet for 20 min.
Centrifuge the cells at 1200rpm for 5min at RT.
Resuspend the cells in 494μl of HBSS
Go back to step 13 in
(B) SLO treatment (Reference: “Permeabilization of donor cells” at www.collaslab.net) Preparation of SLO stock solution Dissolve the SLO powder in water to 100μg/ml on ice
Sterilize the SLO solution through a sterilizing filter
Aliquot 10μl in 200μl tubes
Store at -20℃
Methods Dilute the SLO stock solution 1:10 in HBSS
Resuspend the cells in HBSS and aliquot 500,000 cells per reaction in 1.5ml tubes
Centrifuge the cells in 1.5ml tubes (300g, 5 min, 4℃).
Resuspend with 488μl of HBSS using a 1000μl-pipette.
Incubate the cells at 37℃ for 2 min
Add 12μl of diluted SLO solution
Incubate at 37℃ for 50 min
Collect the cell suspensions from all reaction tubes into a 15ml conical tube
Centrifuge cells in the conical tube (400g, 10min, 4℃)
Resuspend cells in 494μl of HBSS using a 1000μl-pipette
Go back to step 13 in
****Try to extend the incubation time to 20 min if the cells don’t form cell clusters. *****Remove the supernatant very carefully as if to wipe off an inner wall of the conical tube. The left-over Lympholyte solution prevent cells from forming cell clusters. Typical Result picture2 STAP cell cluster derived from Oct4-GFP mice Bright field (left), Oct4-GFP (middle), Autofluorescence (right) These photos were taken during the STAP verification experiment in Riken CDB PAGETOP
STAP HOPE PAGE
HOME
Past background of STAP
Protocol for STAP cells
Results of the STAP verification experiment
Announcement
News
|
スパムメールの中から見つけ出すためにメールのタイトルには必ず「阿修羅さんへ」と記述してください。